Design And Construction Of Microcontroller Based Domestic Remote Control

Design And Construction Of Microcontroller Based Domestic Remote Control

Domestic Remote Control

ABSTRACT
The need for a remote control system that can control domestic appliances and various lighting points and sockets has often been a concern for uses at times uses find it inconvenient and time they are leaving the house for work it has also often led to damage of appliances due to the fact that an appliances was not timed off before leaving the house.
The objective of putting up. This project therefore is to design equipment that can facilitate a convenient and easy way of controlling our domestic appliances lighting points and sockets especially in powering by ourselves. This objective will be accomplished using various components which include a microcontroller project together with other component.
TABLE OF CONTENT
Title Page
Certification
Dedication
Acknowledgement
Abstract
CHAPTER ONE:
INTRODUCTION
1.1     Objective of Project
1.2     Justification of Project
1.3     Scope of Diagrams in Project
1.4     BLOCK DIAGRAM OF PROJECT
1.5     PROJECT  REPORT ORGANIZATION
CHAPTER TWO
LITERATURE REVIEW
2.1     REVIEW OF REMOTE CONTROL SYSTEMS
2.2     DESCRIPTION OF PROJECT
2.3     USE OF PROJECT
CHAPTER THREE
METHODOLOGY
3.1     INFORMATION GATHERING
3.2     HARDWARE COMPONENTS ANALYSIS
3.2.1  Transformers
3.2.2  Bridge Rectifier
3.2.3  Diodes
3.2.4  Capacitors
3.2.5  Voltage Regulator
3.2.6   Light Emitting Diode
3.2.7   Resistors
3.2.8   MICROCONTROLLER
3.2.9  CRYSTAL OSCILLATORS
3.2.10 TRANSISTOR
3.2.11 RELAYS
3.2.12 INFRA RED TRANSMITTERS AND RECIEVERS
3.3     SYSTEM DESIGN APPROACH
3.4     CHOICE OF DESIGN
3.5     THE PROCESS FLOW  CHART
CHAPTER FOUR
DESIGN
4.1     THE HARDWARE SUBSYSTEMS
4.1.0   Basic Power Supply Design
4.2     Microcontroller (AT89C51)
4.3     THE INPUT INTERFACE DESIGN
4.4     THE OUTPUT INTERFACE DESIGN
4.5     CONTROL SOFTWARE PROGRAM DESIGN
CHAPTER FIVE
SYSTEM TESTING, IMPLEMETATION AND EVALUATION
5.1     SYSTEM TESTING
5.1.0  Test Plan
5.1.1  Test Data
5.2     CHOICE OF PROGRAMING LANGUAGE
5.3     EXPECTED TEST RESULTS
5.4     PERFORMANCE EVALUATION
CHAPTER SIX
SUMMARY AND CONCLUSION
6.1    SUMMARY
6.2     PROBLEMS ENCOUNTER
6.3     CONCLUSION
         REFERENCES
         APPENDIX A
         APPENDIX B

About admin

Check Also

DESIGN AND CONSTRUCTION OF A HUMAN DETECTION ROBOT

DESIGN AND CONSTRUCTION OF A HUMAN DETECTION ROBOT Format: Ms Word Document Pages: 73 Price: …

DESIGN AND CONSTRUCTION OF A PASSWORD BASED CIRCUIT BREAKER

DESIGN AND CONSTRUCTION OF A PASSWORD BASED CIRCUIT BREAKER Format: Ms Word Document Pages: 73 …

DESIGN AND CONSTRUCTION OF EXPLOSIVE DETECTION SYSTEM

DESIGN AND CONSTRUCTION OF EXPLOSIVE DETECTION SYSTEM Format: Ms Word Document Pages: 73 Price: N …

DESIGN AND CONSTRUCTION OF DEAD MAN’S SWITCH

DESIGN AND CONSTRUCTION OF DEAD MAN’S SWITCH Format: Ms Word Document Pages: 73 Price: N …

DESIGN AND CONSTRUCTION OF BATTERY LEVEL INDICATOR

DESIGN AND CONSTRUCTION OF BATTERY LEVEL INDICATOR Format: Ms Word Document Pages: 73 Price: N …

DESIGN AND CONSTRUCTION OF A 3-PHASE IRRIGATION WATER PUMP CONTROLLER F USING DUAL GSM MODEMS

DESIGN AND CONSTRUCTION OF A 3-PHASE IRRIGATION WATER PUMP CONTROLLER F USING DUAL GSM MODEMS …

Leave a Reply

Your email address will not be published. Required fields are marked *