Construction Of Digital Water Level Controller

CONSTRUCTION OF DIGITAL WATER LEVEL CONTROLLER

Water Level Controller

ABSTRACT

Technological advancement has cuts across all aspect of human activities. However, it is on this platform that the need to minimize or check water wastage arouse. Water is a free gift of nature but due to its indispensability to human existence; it should be conserved for the purpose of constant availability or sufficiency. Moreover, in order to take a good care of this problem of wastage, there is need for the construction of water level controller this will guide against unnecessary wastage of water, for it will make a reasonable quantity of water to be used a any time. In this project, effort has been made to construct a water controller that is capable of controlling the electric water pumping motor operation in regard o switching “ON” or “OFF” at predetermined level of water in the storage tanks or reservoirs. This project also gives the clarity of advantage of using an automatic method of controlling water level over human or manual control method.
TABLE OF CONTENT

Title page
Certification
Dedication
Acknowledgement
Abstract
Table of content i

CHAPTER ONE

1.0 Introduction
1.1 Motivation
1.2 Layout of reports

CHAPTER TWO

2.0 Literature review
2.1 Digital concept, logic gate symbol and truth table
2.2 The complementary metal oxide silicon
integrated circuits (CMOSIC)

Resistor, capacitor and transistors
Relay

CHAPTER THREE

3.0 Units design calculation
3.1 The power supply unit
3.2 The rectifier stage
3.3 Power supply regulation and sensing/control unit
3.4 Switching circuit design calculation
3.5 Mode of operation

CHAPTER FOUR

4.0 Performance text and analysis
4.1 Casing and its diagram
4.2 Block diagram

CHAPTER FIVE

5.0 Conclusion and recommendation
5.1 Bill of engineering measurements and evaluation (BEME)
5.2 References
CHAPTER ONE

1.0 INTRODUCTION

Water is one of the most important natural resources that need to be conserved, but the rate at which water is being wasted in both he domestic and industrial activities is quite learning however, in a bid to reduce this kind of wastage in some industries, effort has been made towards the design of a “re – circulation system” in which water that has been used is made to recycle and be used again for the production processes.

In some homes is the make use of the overhead reservoirs, there s the need to make use of electric motors for the purpose of pumping water by electric motor in to these reservoirs stop usually depends on the capacity of the reservoirs (that is the time at which water fills the reservoirs to the brim) this however, usually brings about “forced leakages” through the month of the overhead tanks or reservoirs and hence, the whole environment or surroundings will become flooded with waters. This is of course, an abnormal condition.

Moreover for this reason and others that will be mentioned later, there arises the need to develop an efficient and effective means of controlled the level at which water will be pumped in the reservoirs in house and industries in order to reduce wastage of water, loading at the environments and host of other. This a water level controller that will be a supervisory system for monitoring the level of water, which a particular reservoir can contain, needs to we designed and constructed, such that when the water reaches the level at which the probe detectors of the controller are set in the tanks, the motor automatically stopped and alarm to indicate that the volume of the water pumped is enough has to be incorporated.

1.1 MOTIVATION

Of all the existing method of water conservation ranging from the privative manual control to the use of “float” to control the pumped action of the electric motors, there has not been a complete electronic method of control. In the manual control, bring compelled to climb up to a reservoir in which water in being pumped by an electric motor, in order to determined the level of the required water and for which the motor should be stopped, be not the best way of using qualified manpower. Besides, this offers a very tedious working condition to the working personnel’s on the whole.
However; improper way of controlling the water level in the overhead tanks or reservoir is contributing to the problem of water wastage and environmental flooding which can lead to inconvenience for the people around, damage of the property and other valuable materials in homes and industries. Water Level Controller
Hence, the real motivation in having this supervisory unit equipment is based on its advantages of the ability to detect the presence of water at a predetermined level and then controlling of the pumping operation in basically completed electronic mode, the advantage which reduces the problems associated age which reduces the problems associated with improper way of water level centered.Water Level Controller

1.2 LAYOUT OF REPORT

The report layout all the proceedings involve in the project from chapter one to chapter five.

Chapter one discusses introduction, which covers the motivation.
Chapter two deals with the literature review and the general knowledge of entire system .Water Level Controller
Chapter three is on the system design, calculation and mode of operation.
Chapter four describes he constructions testing and problems encountered as well as the courses of the project.
Chapter five presents conclusion and the recommendation.Water Level Controller

About admin

Check Also

DESIGN AND CONSTRUCTION OF A HUMAN DETECTION ROBOT

DESIGN AND CONSTRUCTION OF A HUMAN DETECTION ROBOT Format: Ms Word Document Pages: 73 Price: …

DESIGN AND CONSTRUCTION OF A PASSWORD BASED CIRCUIT BREAKER

DESIGN AND CONSTRUCTION OF A PASSWORD BASED CIRCUIT BREAKER Format: Ms Word Document Pages: 73 …

DESIGN AND CONSTRUCTION OF EXPLOSIVE DETECTION SYSTEM

DESIGN AND CONSTRUCTION OF EXPLOSIVE DETECTION SYSTEM Format: Ms Word Document Pages: 73 Price: N …

DESIGN AND CONSTRUCTION OF DEAD MAN’S SWITCH

DESIGN AND CONSTRUCTION OF DEAD MAN’S SWITCH Format: Ms Word Document Pages: 73 Price: N …

DESIGN AND CONSTRUCTION OF BATTERY LEVEL INDICATOR

DESIGN AND CONSTRUCTION OF BATTERY LEVEL INDICATOR Format: Ms Word Document Pages: 73 Price: N …

DESIGN AND CONSTRUCTION OF A 3-PHASE IRRIGATION WATER PUMP CONTROLLER F USING DUAL GSM MODEMS

DESIGN AND CONSTRUCTION OF A 3-PHASE IRRIGATION WATER PUMP CONTROLLER F USING DUAL GSM MODEMS …

Leave a Reply

Your email address will not be published. Required fields are marked *