Multivariable Optimization With Constraints

MULTIVARIABLE OPTIMIZATION WITH CONSTRAINTS

  ABSTRACT

It has been proved that in non linear programming, there are five methods of solving multivariable optimization with constraints.

In this project, the usefulness of some of these methods (Kuhn – Tucker conditions and the Lagrange multipliers) as regards quadratic programming is unveiled.

Also, we found out how the other methods are used in solving constrained optimizations and all these are supported with examples to aid better understanding.

TABLE OF CONTENTS

Title Page                                                                                        i

Approval page                                                                                ii

Dedication                                                                                       iii

Acknowledgement                                                                         iv

Abstract                                                                                           v

Table of Contents                                                                            iv

CHAPTER ONE

1.0     Introduction                                                                           1

1.1     Basic definitions                                                                    3

1.2     Layout of work                                                                      6

CHAPTER TWO        

  • Introduction 9

2.1     Lagrange Multiplier Method                                                         9

2.2     Kuhn Tucker Conditions                                                      19

2.3     Sufficiency of the Kuhn-Tucker Conditions                        24

2.4     Kuhn Tucker Theorems                                                        30

2.5     Definitions – Maximum and minimum of a function                  34

2.6     Summary                                                                               38

CHAPTER THREE

  • Introduction 39

3.1     Newton Raphson Method                                                    39

3.2     Penalty Function                                                                   53

3.3     Method of Feasible Directions                                    57

3.4     Summary                                                                      67

CHAPTER FOUR

4.0     Introduction                                                                 68

4.1     Definition – Quadratic Programming                       69

4.2     General Quadratic Problems                                               70

4.3     Methods                                                                        75

4.4     Ways/Procedures of Obtaining the optimal

Solution from the Kuhn-Tucker Conditions

method                                                                         76

  • The Two-Phase Method 76
  • The Elimination Method 77

4.5     Summary                                                                      117

CHAPTER FIVE

Conclusion                                                                                       118

References                                                                              120

CHAPTER ONE

  • INTRODUCTION

There are two types of optimization problems:

Type 1

Minimize or maximize         Z = f(x)                          (1)

XE Rn

Type 2

Minimize or maximize         Z  =  f(x)                        (2)

Subject to     g(x)  ~ bi,  i, = 1, 2, —–, m   (3)

where x E Rn

and for each i, ~ can be either <, > or =.

Type 1 is called unconstrained optimization problem.  It has an objective function without constraints. The methods used in solving such problem are the direct search methods and the gradient method (steepest ascent method).

In this project, we shall be concerned with optimization problems with constraints.

The type 2 is called the constrained optimization problem.  It has an objective function and constraints.  The constraints can either be equality (=) or inequality constraints (<, >).

Moreover, in optimization problems with inequality constraints, the non-negativity conditions, X >0 are part of the constraints.

Also, at least one of the functions f(x) and g(x) is non linear and all the functions are continuously differentiable.

There are five methods of solving the constrained multivariable optimization.  These are:

  1. The Lagrange multiplier method.
  2. The Kuhn-Tucker conditions
  3. Gradient methods
    1. Newton-Raphson method
    2. Penalty function
  4. Method of feasible directions.

The Lagrange multiplier method is used in solving optimization problems with equality constraints, while the Kuhn-Tucker conditions are used in solving optimization problems with inequality constraints, though they play a major role in a type of constrained multivariable optimization called “Quadratic programming”.

The gradient methods include:

The Newton-Raphson method and the penalty function.  They are used in solving optimization problems with equality constraints while the method of feasible directions are used in solving problems with inequality constraints.

BASIC DEFINITIONS

  1. NEGATIVE DEFINITE:

The quadratic form XT Rx is negative definite if (-1)i+1 Ri<0, i = 1(1)m.

Using (-1)i+1 Ri<0.

When i = 1  à  (-12 R1 <0  à R1 < 0

i = 2 à (-1)3 R2 < 0  à  R2 < 0: R2 > 0

i = 3 à (-1)4 R3 < 0   à  R3 < 0

R1 < 0, R2 > 0, R3 < 0, R4 > 0, ——-

  1. NEGATIVE SEMI-DEFINITE

The quadratic form XT Rx is negative semi-definite if (-1)i+1 Ri < 0 and at least one (-1)i+1 Ri ¹ 0

  1. POSITIVE DEFINITE

The quadratic form XT Rx is positive definite if Ri > 0, i = 1 (1)m.

                   Example:

R  =            r11      r12      r13  – – – – – – –        r1m

                             r21      r22      r23  – – – – – – –        r2m

                             r31      r32      r33  – – – – – – –        r3m

 

                             rm1     rm2     rm3  – – – – – – –       rmm

where

R1  =    r11     > 0

R2  =

r11      r12      > 0

r21      r22

 

  1. POSITIVE SEMI DEFINITE

The quadratic form XT Rx is positive semi definite if Ri > 0, i = 1 (1)m and at least one Ri ¹ 0

  1. CONVEX

The function f is convex if the matrix R positive definite.  Example is f(x).

  1. CONCAVE

A function f is said to be concave if its negative is convex.  Example is   -f (x).

NOTE:

Whether the objective function is convex or concave, it means the matrix is positive definite or negative definite.  When the matrix is positive definite or positive semi-definite, it should be minimized, but when it is negative definite or negative semi-definite, then it should be maximized.

LAYOUT OF WORK

There are five chapters in this project.

Chapter two is dedicated to two methods of solving constrained optimization.  These methods are the Lagrange multiplier method and the Kuhn-Tucker conditions.  This section clearly shows how the Kuhn-Tucker conditions are derived from the Lagrange multiplier method, in an optimization problem with inequality constraints.  As part of this chapter, the global maximum, local maximum and the global minimum of an optimization problem was also derived.

Chapter three presents the gradient methods and the method of feasible directions.  The gradient methods are the Newton Raphson method and the penalty function.

The gradient methods are used in solving optimization problems with equality constraints while the method of feasible directions is used in solving optimization problems with inequality constraints.

Chapter four is specifically on a type of multivariable optimization with constraints.  This is called “Quadratic programming”.  This chapter comprises of quadratic forms, general quadratic problems and it shows the importance of two methods called the Lagrange multiplier method and the Kuhn-Tucker conditions.  This section explains how we can arrive at an optimal solution through two different methods after the Kuhn-Tucker conditions have been formed.  These are the two-phase method and the elimination method.

Chapter 5 is the concluding part of this project.

Each chapter starts with an introduction that facilitates the understanding of the section and also contains useful examples.

In conclusion, this research will make us understand the different methods of solving constrained optimization and how some of these methods are applied in quadratic programming.

About admin

Check Also

Statistical Analysis Of Students’ Expenditure In Tertiary Institutions A Case Study Of IMT Enugu 2004/2005 Sessions

Research project topic on Statistical Analysis Of Students’ Expenditure In Tertiary Institutions A Case Study …

A QUALITY ANALYSIS OF THE THICKNESS OF PART AND CORRUGATED ASBETES ROOFING SHEETS OF EMENITE LIMITED ENUGU

RESEARCH PROJECT TOPIC ON A QUALITY ANALYSIS OF THE THICKNESS OF PART AND CORRUGATED ASBETES ROOFING …

Regression Analysis On National Income (From 1998 – 2003 A Case Study Of Federal Republic Of Nigeria)

Research project topic on Regression Analysis On National Income (From 1998 – 2003 A Case …

THE EFFECTS OF MODERN COMMUNICATION EQUIPMENT ON THE SECRETARIAL PERFORMANCE. (A CASE STUDY OF NB PLC-ENUGU).

RESEARCH PROJECT TOPIC ON THE EFFECTS OF MODERN COMMUNICATION EQUIPMENT ON THE SECRETARIAL PERFORMANCE. (A CASE …

AN ANALYSE OF INFANT MORTALITY RATE IN ABIA STATE. (A CASE STUDY OF FEDERAL MEDICAL CENTRE UMUAHIA FROM 1995 TO 2004)

RESEARCH PROJECT TOPIC ON AN ANALYSE OF INFANT MORTALITY RATE IN ABIA STATE. (A CASE STUDY …

A STATISTICAL APPRAISAL ACCIDENT RATE IN ENUGU – ONITSHA EXPRESS ROAD FROM 1995 – 2002

RESEARCH PROJECT TOPIC ON A STATISTICAL APPRAISAL ACCIDENT RATE IN ENUGU – ONITSHA EXPRESS ROAD …

Leave a Reply

Your email address will not be published. Required fields are marked *