Home / ELECTRICAL AND ELECTRONICS ENGINEERING PROJECT TOPICS AND MATERIALS / DESIGN AND INSTALLATION OF 200 WATT SOLAR POWER SYSTEM

DESIGN AND INSTALLATION OF 200 WATT SOLAR POWER SYSTEM

DESIGN AND INSTALLATION OF 200 WATT SOLAR POWER SYSTEM

CHAPTER ONE
INTRODUCTION
1.1 NEED FOR THE PROJECT

The general objective of the system is to provide efficiency, steadiness in the use of power appliances, by ensuring continuous availability of power supply even in the absence of mains. Uninterruptability of the system made it possible to eliminate all suspense from mains outage during the execution of an important and urgent assignment as may be required.

For better production of the system, the system was operated at a fully charged condition of the battery.

The project was rated 200W of 220V and 50Hz. It was expected that at this condition, it was favourable to carry load of the stipulated power. Loads of low power factors are not helpful since they produce spikes. Overloading is not potent to provide zero change over time and the inverter had LEDs which indicates mains failure and battery discharge and system fault.

1.2 SCOPE OF STUDY

This solar power source makes it possible to provide a clean reliable supply of alternative electricity free of sags or surges which could be found in the line voltage frequency.

The solar power system (SPS) system achieved this by direct current from solar panel and by rectifying the standard main supply, using the direct current to charge the batteries and to provide clean alternative power by passing the energy a filter system.

It has zero change over time and LEDs which indicates mains fail and battery discharge level and it provides 100% protection against line noise, spikes surges and audio frequency interference.

1.3 DEFINITION OF TERMS
1. Inverter unit: This unit converts a DC voltage into AC voltage with the help of the inverter unit.

  1. Automatic Control Unit: This provides all the required control needed to meet up the objective of the whole system

  2. Battery Unit: This is a secondary cell unit, capable of storing enough DC voltage from either sun or AC main, of which is later converted to AC voltage.

Sharing is caring!

About admin

Check Also

Environmental Science Project topics

CONSTRUCTION OF MICROCONTROLLER BASED VEHICLE SPEED ALARM.

CONSTRUCTION OF MICROCONTROLLER BASED VEHICLE SPEED ALARM. Format: Ms Word Document Pages: N/A Price: DOC N …

Environmental Science Project topics

CONSTRUCTION OF AUTOMATIC WATER LEVEL CONTROLLER FOR BOTH OVERHEAD AND UNDERGROUND TANKS

CONSTRUCTION OF AUTOMATIC WATER LEVEL CONTROLLER FOR BOTH OVERHEAD AND UNDERGROUND TANKS Format: Ms Word …

Environmental Science Project topics

CONSTRUCTION OF A MICROCONTROLLER BASED T-JUNCTION TRAFFIC LIGHT CONTROLLER

CONSTRUCTION OF A MICROCONTROLLER BASED T-JUNCTION TRAFFIC LIGHT CONTROLLER Format: Ms Word Document Pages: N/A Price: DOC/ …

Environmental Science Project topics

CONSTRUCTION OF A MICROCONTROLLER BASED SECURITY USING SMART CARD

CONSTRUCTION OF A MICROCONTROLLER BASED SECURITY USING SMART CARD Format: Ms Word Document Pages: N/A …

Environmental Science Project topics

CONSTRUCTION OF A GSM BASED HOME AUTOMATION USING AVR

CONSTRUCTION OF A GSM BASED HOME AUTOMATION USING AVR Format: Ms Word Document Pages: N/A …

PATIENT HEARTBEAT AND TEMPERATURE MONITOR

PATIENT HEARTBEAT AND TEMPERATURE MONITOR CHAPTER ONE INTRODUCTION 1.1 BACKGROUND Heart beat rate means the …

Leave a Reply